@Grayda If you run the packet logger in 'Compact' mode it does group by message ID. This is the default mode. What I've been doing is just logging and watch for a line in the table to change when I press a button in the car.
Help me understand a little better how I could make the workflow easier. Thanks!
I finally upgraded to Win8.1, so got to briefly check out the app today. Looks good, easy to navigate.
Did have a issue when attempting to upgrade Firmware from .4.2 with it. CBT rebooted but the app hangs at uploading firmware. Have to close and reopen it when that happens. I haven't had time look into it further yet.
Just to add I am having some issues with the Mac app. If I start up fresh, then plug in USB for the CBT. Boot up the app. Press logger and connect via USB. I then plugin my ribbon cable and no logging. If I then unplug the ribbon and USB and open CoolTerm plugin USB, connect. Run 030101 then plugin ribbon. I get flooded with data. I disconnect from CoolTerm and switch to CBT App then tell it to connect via USB again. At that point I will see data in the CBT app just fine. If I turn on the wireshark piping logging stops. Also there doesn't appear to be any sort of log dump from the CBT app, I assume because we would choose to do that with Wireshark. So I am kind of stuck at this point with the app. I will have to see about tracking down a windows laptop to see if I get different results there.