Last Online
Recent Posts
posted in Firmware read more

Mine had the same problem. I finally rebooted, and the firmware now shows up in the white box.

posted in Hardware and Wiring read more

I am working with a 2002 corvette and a Buick 2011 enclave. After looking at pin outs, I think the cable is correct. Must be another issue somewhere. I will keep changing/checking things until it works. :)

posted in Hardware and Wiring read more

Today, I am unable to get data to the canbus triple, so I took a look in the connector that fits into the odb port.

This is what I found:

Pin 6 - red wire
Pin 14 - green wire
pins 4 and 5 - white wire
Pin 16 - back

There is a blue wire but it is not connected to anything. Can someone verify this is the way the corrector should be wired?

Thanks much!