Behind the instrument cluster
you looking for
Twisted Pair
HS CAN HIGH - White 1 stripe
HS CAN LOW - Red 1 stripe
Twisted Pair
MS CAN High - Green 1 stripe
MS CAN Low - Grey 1 stripe
Arrows Buttons - Brown w/ 2 Stripes
Nav/Info/Back Buttons - Sky Blue w/ 2 stripes
The updated mazda3 hex works perfect now. But now ibwas to change what pids display how do i do that?
i have tried to flash CANBusTriple_Mazda and i also did jumper the terminating resistors. nothing shows up on the screen not even my mpgs its just blank.
HS Bus should have some wires going to the instrument cluster
i snipped the MS CAN line and wired can 1 to one side and can 3 to the other side then can2 is wired to the HS can and the arrows and back buttons wired to analong 0 and 1. but now i have another issue. my traction control light comes on when just idling and goes away when i drive could this cause that issue?
i tried to use the mazda hex and couldnt get any info show on teh diplay as soon as i flash the CANBusTriple.cpp.hex all my stock information begins to display again. i have a aftermarket headunit if that makes a difference,